Jump to content

Create a Point at a middle of Mesh or Surface or UCS..


Deby Ferdian

Recommended Posts

Is a possible if I want to put a Point at a middle of Mesh or Surface or UCS ?

I have a routine to finding a cetroid of Solid, Region, Line, Polyline, Close Polyline. But the routine won't finding a centroid of Mesh, Surface and Planesurface..

 

That's why I though I also should looking for routine which it's can be finding for centroid of UCS..

CreatePoint@middle of Mesh or Surface or Ucs!.jpg

Link to comment
Share on other sites

But my purpose is want to put a point at the UCS or If can be done to put a point at center of MESH and SURFACE ???

Edited by Deby Ferdian
Link to comment
Share on other sites

Finally, yes.. I have been successfully did it very well! I did it still in AutoCAD and not need to migrate to other program of CAD application else or convertion beforehand. All I have to do is just create a point but the first I should be in a "Zcen" 3dsnap mode in firstly and then I use a "meet two point (mtp)" and thatha.. well done! hehe.. although of it I'm still doing this with manually methode. I attached my sample of review!

CreatePoint@middle mesh or surface or ucs.jpg

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...