Jump to content

Don't you hate it when....


squareknees

Recommended Posts

I thought I would post here because it doesn't seem to fit anywhere else...

I just realized that there is an easier way to do something and I thought it would be cool if others posted a command that would make life easier.

 

 

I was going through to change a bunch of blocks from one label to another when I realized that I could have grabbed them all and used the properties box to change them all at once.. I wish I would have realized that before I spent 10 minutes changing them one at a time

 

 

one of my favorite commands is -ch where you can straighten out any slightly angled line to an increment of 90 degrees.

to use the command you have to have ortho on, type in -ch and pick line then the end of the line you want straightened.

 

 

what tips do you have??

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...