ReMark Posted May 26, 2016 Share Posted May 26, 2016 I think the OP said at one point there could even be less than 100 holes in a face. We update our standards constantly; no one follows them though. Quote Link to comment Share on other sites More sharing options...
BIGAL Posted May 27, 2016 Share Posted May 27, 2016 I did do some where here a random circle code and it checked via "WP" to see if it touched another object and if not drew a new one . So it could be automated. Like prior posters it could stop before 100 not find a gap so it would be wise to start at 100mm. Something about Light penetration. Quote Link to comment Share on other sites More sharing options...
TheCADnoob Posted May 27, 2016 Share Posted May 27, 2016 I think this is what he is going for http://www.solidsmack.com/3d-cad-technology/this-new-composite-metal-foam-can-shield-radiation-and-stop-bullets/ Quote Link to comment Share on other sites More sharing options...
Campaigner Posted May 28, 2016 Author Share Posted May 28, 2016 Thanks for that. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.