Jump to content

Dimensioning Problem


theinventor87

Recommended Posts

I am learning Autodesk Inventor and am having trouble adding a certain dimension to a slot to a product I am embedding into a 2D sketch.

 

Attached is a screenshot that portrays the issue I am facing. Thank you in advance for your assistance.

 

Slot Dimension.png

Link to comment
Share on other sites

Welcome to CADTutor. :)

 

Sorry I can't answer your question, as I don't use Inventor, but Inventor questions should be posted in the Inventor Forum, thus increasing the likelihood that Inventor users will see them, and respond.

 

If I read your post correctly, it sounds like you haven't modeled the slotted hole into your model?

Which seems different than how I would expect it to be done.

Link to comment
Share on other sites

  • 2 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...