Jump to content

Restricted rotation on Dynamic Block


deejaydave

Recommended Posts

Hi all, I am new to the forum, but a long time user of AutoCAD.

 

 

I have a question concerning dynamic blocks. I have created a block that has a couple of rotational points, but I don't want them to rotate 360°.

One of the points can only be rotated 110° CW and CCW, the other 145° CCW and 150° CW. The question is can this "Can you actually put a constraint on these points so that they can't be rotated past these angles?"

 

 

Thanks

Link to comment
Share on other sites

In the block editor if you highlight the rotation parameter and open your properties palette, there is an option to set the minimum and maximum angles, or you can also limit the input to a list of values. I can't comment about constraints as LT doesn't have those available.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...