Jump to content

Ucs


herguth1

Recommended Posts

I'm in AutoCAD 17. I'm building a simple 3D model. I want to draw a polyline using points on a solid object, prism. The UCS is set to the correct plane. I initiate the pline command. As soon as I pick my starting point the UCS icon jumps to that point and assumes the "world" orientation. What's going on?

Link to comment
Share on other sites

Maybe try turning Dynamic UCS (DUCS) to off. There is an icon at the bottom for DUCS, looks like a UCS but with a tiny lightning bolt on one leg. It was so much easier when we could have letters instead of icons down there.

Link to comment
Share on other sites

Maybe try turning Dynamic UCS (DUCS) to off. There is an icon at the bottom for DUCS, looks like a UCS but with a tiny lightning bolt on one leg. It was so much easier when we could have letters instead of icons down there.

 

I believe F6 will toggle it on and off. :beer:

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...