1. ## Dynamic Block

Registered forum members do not see this ad.

Hello all,
I have a drawing of a rail with holes in it.
The holes at the edges are Fixed with fixed length, in the middle the distance between each hole is changing when i change the Length of the rail, but cant pass 40 cm from each outher(the divide needs to be equal between the middle holes)
Any way to make the same calculate with the dynamic block?
In outher simple words i need dynamic divide in the dynamic block

Thank you,
Doron

Drawing1.dwg

2. Do you need more holes to be created as you stretch the block and you need them to be equal distance apart?

3. Not sure if this is what your looking for but it's a start. It's not a solution but should get you on the right track.

4. Pretty sure same question has been answered here before where as you stretch extra holes are added based on a center point but has a max end distance to the hole.

Any one remember ?

5. wow thank you for the help...
Ski_Me the attached you post was very close but the holes need to be divided in center until the distance passes the 40 cm after it passes another hole is created ,and on and on...

Rail.dwg

6. I was hoping someone would remember the older post. Whilst dynamic blocks is the way to go you can do the same old fashioned way with a lisp. Ask a few questions and draw it. (A-300)/400= howmany holes.

7. http://forums.autodesk.com/t5/dynami...n/td-p/6546727
this is what i need..
but when i try to make it on my draw its not working and the lines mix
Test Block Window -.dwg

8. Originally Posted by doronz
http://forums.autodesk.com/t5/dynami...n/td-p/6546727
this is what i need..
but when i try to make it on my draw its not working and the lines mix
Attachment 59413

Test Block Window -.dwg
Did it
Thank you all for the help
sorry for double posting

9. Well Done dorozn.

10. Registered forum members do not see this ad.