Jump to content

centerline command in 2017


masterfal

Recommended Posts

hi all,

 

i've switched to 2017 somewhat recently after using running 2011 and found i've been using this centerline command alot. not sure which version of cad it got added to but i'm a fan. i had a lisp routine that i used to do this previously but it would sometimes return a skewed line, so couldn't always rely on it to work properly.

 

Anyway, does anyone know if its possible to edit the linetype for the line thats generated when the centerline command is run? at the moment it seems to be set to "center2". I'd like it to just be a continuous line if possible. should be able to specify that somewhere, just unsure where?

 

(i tried tricking it by changing linetype scale for center2 linetype to 100 so as to make it look like continuous line but after the centerline command is run it generates the line with linetype scale of 1..)

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...