Jump to content

2D solid surfaces in autocad 2000


symysgames

Recommended Posts

Hello

I am trying to understand the logic behind the display of 2D solid surfaces in autocad 2000. if you have a same area covered by different 2d surfaces in different layers with different colour which layer or surface hides what surface or layer. Does it depend on the order they are created, does it depend on the colour , is there a method to make one layer cover another. All layers must be on.

And what about lines that cross these surfaces , some times they show and some times they don't. Is there a logic behind this? :?

Thanks in advance for your answers

Link to comment
Share on other sites

Thank you for you proposition, that won't be necessary ,when I plot the file everything is fine and it I export the file it's ok and when I reload the drawing it's ok it's when I do a regen then I can't always see what I should. Thanks again

Link to comment
Share on other sites

  • 3 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...