chubarka Posted November 23, 2016 Share Posted November 23, 2016 Will someone here point out a method to apply a radius to the flat part shown in my attachment, similar to the shaped part? The radius is 2.6". I have never used the flex tool, would that be a possibility? Thank you, Chubarka Quote Link to comment Share on other sites More sharing options...
shift1313 Posted November 24, 2016 Share Posted November 24, 2016 Flex will work but you Could Sweep it, male it from sheet metal or a few other methods. I would use sheet metal most likely but don't know what 2007 had. Sweep is my next option. Quote Link to comment Share on other sites More sharing options...
chubarka Posted November 24, 2016 Author Share Posted November 24, 2016 I know how to use the sweep feature, however that had to be employed from the start, I need to bend this part now that it is all pierced and formed. I don't know if sheet metal will put on the radius with the flange on it, I'm going to have to look into the flex tool. I suppose. Thank you for your response, Chubarka Quote Link to comment Share on other sites More sharing options...
shift1313 Posted November 24, 2016 Share Posted November 24, 2016 I have some videos ill find for you. Quote Link to comment Share on other sites More sharing options...
chubarka Posted November 24, 2016 Author Share Posted November 24, 2016 Thank you so much! Quote Link to comment Share on other sites More sharing options...
shift1313 Posted November 24, 2016 Share Posted November 24, 2016 i just emailed you a video. I didn't ever put it on my website but it should get you started. Let me know if you have questions. Flex is a tricky tool. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.