Jump to content

Save not working properly


Robert Newton

Recommended Posts

When I opened the "1st Attempt 3D Model.2dwg" file you provided in post #11 above, and checked the UCSFOLLOW variable, it was set to 1, so I changed it to 0.

 

I also set the SKYSTATUS variable to 0. In your file it was set to 2. In order to set it to 0, you must first set it to 1, and then set it to 0. You can't go directly from 2 to 0.

 

Changing UCSFOLLOW and SKYSTATUS fixed the saving problem for me, but I see that the zoom extents issue is still happening. Just run a PURGE and delete the blocks. You will have to PURGE twice in order to eliminate all the blocks. That should fix the zoom extents issue.

Link to comment
Share on other sites

  • Replies 24
  • Created
  • Last Reply

Top Posters In This Topic

  • Robert Newton

    13

  • ReMark

    4

  • Cad64

    4

  • Dadgad

    2

Top Posters In This Topic

Posted Images

The attached images indicate that I have done as directed and still no luck with Zoom Extents. Thanks to all of you have had input on attempting to correct my problem.

After Zoom Extents.jpg

skystatus.JPG

ucs follow.JPG

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...