jabastin Posted October 5, 2009 Posted October 5, 2009 Dear all:) After i set the the value of pellipse to 1. i could not draw the elliptical arc.why? Kindly tell that what's the reason for that. anticipating asap.... Quote
ReMark Posted October 5, 2009 Posted October 5, 2009 Not sure why that would be. Afterall, setting PELLIPSE to 1 just creates a polyline representation of an ellipse. Quote
rkmcswain Posted October 5, 2009 Posted October 5, 2009 You just can't. Just use the BREAK command after drawing the entire ellipse, or check this for another solution: http://discussion.autodesk.com/forums/message.jspa?messageID=6257373 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.