MRAKA Posted September 1, 2010 Posted September 1, 2010 Has any one had this problem. Quite often (more so today) when I am using the arc option in the polyline command my AutoCAD crashes? Any help would be greatly appreciated. Andrew Quote
ReMark Posted September 1, 2010 Posted September 1, 2010 When did the problem first occur? Is it just a particular drawing or any drawing? Quote
MRAKA Posted September 1, 2010 Author Posted September 1, 2010 It started this week and its is happening on most drawings large or small Quote
ReMark Posted September 1, 2010 Posted September 1, 2010 Any other commands causing AutoCAD to crash? What is the source of the drawings? Any from an outside vendor or client? Quote
MRAKA Posted September 2, 2010 Author Posted September 2, 2010 It is happening on all drawings. Today is it crashing when I qsave now!. Error mssg 0xlc 5lca2 exception at 27130111h Quote
MRAKA Posted September 2, 2010 Author Posted September 2, 2010 Is this a command as the command line doesnt recognise? Quote
ReMark Posted September 2, 2010 Posted September 2, 2010 Is this a command as the command line doesnt recognise? No, it isn't. It's an option that is available through the Windows Control Panel. But before we get to that do you have a Windows Restore Point that could get you back in time before the problems started occuring? Have there been any changes to hardware or software prior to the problem surfacing? Quote
BIGAL Posted September 3, 2010 Posted September 3, 2010 Also add networking we had a problem with that Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.