Jecobin Posted September 28, 2011 Posted September 28, 2011 Hi All, Can anyone put me on the right path to form a flat shape of a surface in rhino. For example if I have a plate on the side of a hull how would I go about changing this shaped plate to a flat sheet allowing cutting its actual shape before bending. I would appreciate any help. Regards, John Quote
dedmin Posted September 29, 2011 Posted September 29, 2011 Surface > Unroll Developable Srf or Smash http://www.rhino3d.com/4/help/Commands/UnrollSurface.htm Quote
Jecobin Posted September 30, 2011 Author Posted September 30, 2011 Hi dedmin, Thanks for your reply. I checked out Unroll and found that its works on surfaces with only one curve. On surfaces with double curves it does not work. But it was worth trying and thanks for the tip. Regards, John Quote
dedmin Posted October 1, 2011 Posted October 1, 2011 http://wiki.mcneel.com/labs/advancedflattening Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.