Mechanical 2012 Offset command problem.

It doesn't allow offsetting a selected object anymore?..

My old routine was

1. Select an object

2. Enter Offset command

3. whatever

4. Exit

Now when I start Offset command it deselects my object...

The other commands are working fine with selected objects so far.

Is there any way to make it work as before?

It doesn't allow offsetting a selected object anymore?..

 

My old routine was

 

1. Select an object

2. Enter Offset command

3. whatever

4. Exit

 

Now when I start Offset command it deselects my object...

 

The other commands are working fine with selected objects so far.

Is there any way to make it work as before?

Even though it deselects the object it still works properly here but you might try

setting PICKADD to 2.

It was already 2.

0 or 1 changes nothing.

Nevermind, I made it run as a Classic AutoCAD by removing profile string in the shortcut properties. Back to normal....

Not sure if this is caused by the PICKFIRST sysvar.