Jump to content

Where to set units etc.

IronHorse

By IronHorse
in Autodesk Inventor

 Share

Recommended Posts

IronHorse Community Regular

IronHorse

Posted
Posted

I just Installed Autodesk Product suite 2013, during installation I could not find

where to set units (mm) and drawing standard (ISO) Is there any way to set

this afterwards as default for all programs?

IronHorse Community Regular

IronHorse

Posted
  • Author
Posted
I just Installed Autodesk Product suite 2013, during installation I could not find

where to set units (mm) and drawing standard (ISO) Is there any way to set

this afterwards as default for all programs?

 

I found It, It will be set from start window "configure default template", new way compared to before

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing
×
×
  • Create New...