Jump to content

Drawing too long by 40mm


matt4

Recommended Posts

  • Replies 67
  • Created
  • Last Reply

Top Posters In This Topic

  • matt4

    19

  • skipsophrenic

    11

  • Strix

    9

  • paulmcz

    8

Top Posters In This Topic

Posted Images

Thnx 4 the correction there paul, i think i had a brainmelt

 

I wasn't trying to correct you. I didn't yet see your post when I decided to answer. Now that I read it, you didn't say anything that needed correction.

The question remains, will Matt move on from this point?

Link to comment
Share on other sites

I wasn't trying to correct you. I didn't yet see your post when I decided to answer. Now that I read it, you didn't say anything that needed correction.

The question remains, will Matt move on from this point?

 

Hope so, an thanx - havin hard day at work and its beginning to show i think:(

Link to comment
Share on other sites

Sorry thought this was for addressing problems with autocad.

 

Yes, we try hard to address problems with AutoCAD. It's the OIEs that sometimes end up leading us done the road to frustration, and thus, sarcasm. Just roll with it. Anything else invites real negativity. Do you have any other concerns or problems left unaddressed at this point with AutoCAD or its commands?

Link to comment
Share on other sites

You're welcomed mr. matt. Should you have a new question I suggest posting it as a new thread in the proper forum as opposed to appending to this thread. Good luck with your drawing.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...