skipsophrenic Posted March 4, 2009 Share Posted March 4, 2009 Thnx 4 the correction there paul, i think i had a brainmelt Quote Link to comment Share on other sites More sharing options...
matt4 Posted March 4, 2009 Author Share Posted March 4, 2009 Okay, The dimscale is at 1.0 Thanks for that paulmcz Quote Link to comment Share on other sites More sharing options...
paulmcz Posted March 4, 2009 Share Posted March 4, 2009 Thnx 4 the correction there paul, i think i had a brainmelt I wasn't trying to correct you. I didn't yet see your post when I decided to answer. Now that I read it, you didn't say anything that needed correction. The question remains, will Matt move on from this point? Quote Link to comment Share on other sites More sharing options...
skipsophrenic Posted March 4, 2009 Share Posted March 4, 2009 I wasn't trying to correct you. I didn't yet see your post when I decided to answer. Now that I read it, you didn't say anything that needed correction.The question remains, will Matt move on from this point? Hope so, an thanx - havin hard day at work and its beginning to show i think:( Quote Link to comment Share on other sites More sharing options...
matt4 Posted March 4, 2009 Author Share Posted March 4, 2009 Sorry thought this was for addressing problems with autocad. Quote Link to comment Share on other sites More sharing options...
ReMark Posted March 4, 2009 Share Posted March 4, 2009 Sorry thought this was for addressing problems with autocad. Yes, we try hard to address problems with AutoCAD. It's the OIEs that sometimes end up leading us done the road to frustration, and thus, sarcasm. Just roll with it. Anything else invites real negativity. Do you have any other concerns or problems left unaddressed at this point with AutoCAD or its commands? Quote Link to comment Share on other sites More sharing options...
matt4 Posted March 4, 2009 Author Share Posted March 4, 2009 ReMark, Nothing I can think of at this time. If I do I shall ask. Thanks, Quote Link to comment Share on other sites More sharing options...
ReMark Posted March 4, 2009 Share Posted March 4, 2009 You're welcomed mr. matt. Should you have a new question I suggest posting it as a new thread in the proper forum as opposed to appending to this thread. Good luck with your drawing. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.