Jump to content

posting a text in isometric


edwardmchale

Recommended Posts

I seem to be having trouble posting a text in NE isometric. I tried to convert to layout but no images appeared

 

While in the NE iso view, rotate the UCS about the Z 90 or 180 degrees. You can also use UCS, 3point, pick a corner of your object, you next point is X and would be following the length of the text, the next point would be Y and would run along the height of the text.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...