arsalan_gz Posted February 23, 2017 Share Posted February 23, 2017 Hello everyone, It might sound a bit too beginner but once I can remember that once I used a command by which I could not only display the x and y coordinate of a point on the project, but also keep them shown on the point which would be there after printing and both coordinates would be shown with a single click on a point. now I have forgotten how I actually did it. Quote Link to comment Share on other sites More sharing options...
BIGAL Posted February 24, 2017 Share Posted February 24, 2017 Search label x y etc its a lisp, you can also use a block and a field, mtext and a field. Quote Link to comment Share on other sites More sharing options...
arsalan_gz Posted February 24, 2017 Author Share Posted February 24, 2017 Search label x y etc its a lisp, you can also use a block and a field, mtext and a field. Thank you very much. I'll check it and let you know if I could solve my problem. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.