Search the Community

hello, i have completed everything thus far in this project, but i am lost with the elective, i have another week to finish so i can go to school in the fall (sponsored by work safe because of an accident) i was wondering if anyone could provide a screen shot of any or all of the plates, or even if anyone could help me with the elevation where as thats what im stuck on now at the moment, also having a hard time with the pads, footings and concrete retainning wall, i asked p-f and they didnt really help me

Okay so i was doing my HVAC/sheet metal drafting all smoothly, doing all the hvac and vents. until, suddenly, and with out warning, an instruction from the booklet was so confusing, i momentary cannot find out what to do. this is my questions in which im stuck. 3. The eastern portion of the split is 10″ wide and connects almost immediately to a 10 × 14 transition piece. The 14″ × 6″ duct continues south to a point near the sink in Bathroom #2 where it splits into two portions. 4. The west portion forms a 4″ × 4″ duct that bends west and connects immediately to the wall outlet scheduled as S-B2. This outlet is located in the toe clearance between the washbasins in Bathroom #2. The 4″ × 4″ duct exits from the west side of the outlet and continues west to end in Bathroom #1. The very end of the duct connects to the 4″ × 12″ wall outlet scheduled as S-B1. Like the other bathroom’s outlet, this outlet in Bathroom #1 is positioned in the toe clearance between the washbasins. so far i have no understanding of what it means. what are toe clearances? this my work so far plate 1.dwg so can u give me a brief explanation. anyone that helps gets a virtual cookie.