Jump to content
jlunny

Round staircae

Recommended Posts

jlunny

I am drawing a two storey building with a round staircase, I have tried to insert the staircase but it will not work. I have selected the ground and first floors, I have chosen the number of risers, their rise and going and the width of the stairs. The staircase is appearing in my drawing but it only has ten steps and does not reach my second floor level. Can anyone tell me if there are anything I am doing wrong and what should I check to try and solve the problem.

 

Thankyou,

 

J.Lunny.

Share this post


Link to post
Share on other sites
qabulin

Are you just barely missing the second floor by about one riser, +/- a few inches?

 

Got a pic you can post?

 

If your close, then check out the rise type property of the stair (please refer to attached image.)

riser.jpg

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...