Jessica28 Posted September 1, 2010 Share Posted September 1, 2010 I'm running Autocad Mep 2011...I am installing conduit and want to change the radius of the conduit elbows.....I did select the elbow, right clicked, went to its properties where I was able to change the radius but it would only allow me to go bigger....It says "the selected radius of curvature is less than the minimum size allowed for this part. Please enter a larger radius value or select a different nominal size"....Is there a way to make it a tighter bend radius?...Please Help Quote Link to comment Share on other sites More sharing options...
dumfatnhappy Posted September 27, 2010 Share Posted September 27, 2010 you are stuck with the standard bend radii's of 15, 30 60 and 90 degree. to beat it you'll have to sweep a circle or something equal to fake it in there Quote Link to comment Share on other sites More sharing options...
ReMark Posted September 27, 2010 Share Posted September 27, 2010 What radius were you trying to specify? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.