Rgerth Posted September 28, 2010 Share Posted September 28, 2010 I am trying to use Linkslope to surface with a negative slope ( -2%) in an assembly but it will only slope upward. The properties show -2%, the graphic shows this subassembly sloping down but when I check my corridor it only slopes up. I am using Civil 3D 2009. Am I using the wrong subassembly? It is tied to a basic lane that has -2% also. The surface I am tying to is sloping towards my corridor. The distance it should go is approximately 20 feet, but by sloping up it is only going approximately 16 feet. Quote Link to comment Share on other sites More sharing options...
Fcernst Posted June 17, 2021 Share Posted June 17, 2021 You want to choose Fill only to have it slope in the downward direction. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.