Jump to content

3d modeling problem


Maverick2805

Recommended Posts

I am working on the supporting structure right now, once this is finish i'll tilt the barrel maximum up and down to see if it "touches" anywhere else.

 

Tehen there are still the eyebolts to go, which I don't know how small I can produce them in reality :D I'd need about 3.5mm of outer diameter :S

 

Supporting Structure 1.jpg

Link to comment
Share on other sites

  • Replies 75
  • Created
  • Last Reply

Top Posters In This Topic

  • Maverick2805

    37

  • ReMark

    30

  • JD Mather

    2

  • dumfatnhappy

    2

you mean the one overlapping the block for the axle? yes it is tilted and one edge is sitting on that block, plus supported on the top by a bar (not yet integrated)

 

front supporting block.jpg

Link to comment
Share on other sites

I think you are on the right track after all. Could that piece be there to keep the front (muzzle?) of the cannon from falling down and making contact with the deck of the ship? It would also make a good "resting" point and prevent moisture from collecting in the barrel when not in use.

Link to comment
Share on other sites

This might be, it could be a movable part, otherwise it would probably be difficult to rest on something that is almost straight below the tilting point of the barrel. or it has something to do with the cannon moving during a shot. don't know :)

 

Will see when I have time to finish the carronade, it's holiday time 8)

Link to comment
Share on other sites

  • 2 months later...
Hi, i want to know how to create 3D thread holes, coz i making a 3D mould stainless steel, Thanks in advanced for helping me

Welcome to the CADTutor forum winterkk.

 

I suggest that you post your inquiry as a new thread. Tacking it onto this thread is not a good idea. More people will see and respond to your question if it stands on its own.

F.Y.I. - This topic has been covered extensively in the past. I may have some further info for you once you have reposted.

 

Regards,

 

ReMark

Link to comment
Share on other sites

  • 2 weeks later...

That Cannon Seems Pretty Unstable Wheres The Attachment To Lock It In Place?

You can fire that Thing Just Dont Stand Behind IT.

Write Some Formulas

The Wheel Axle Diameter-Radius = The Tire's Inner Axle Hole

 

Weight+Force OF Gravity= Great Resistance To Motion IN The Four Wheels

Link to comment
Share on other sites

That Cannon Seems Pretty Unstable Wheres The Attachment To Lock It In Place?

You can fire that Thing Just Dont Stand Behind IT.

Write Some Formulas

The Wheel Axle Diameter-Radius = The Tire's Inner Axle Hole

 

Weight+Force OF Gravity= Great Resistance To Motion IN The Four Wheels

 

The OP's problem was solved but thanks for the suggestions.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...