NKG Posted September 28, 2008 Share Posted September 28, 2008 Hi, ACAD2009, I have a DWG with 15 layouts and I've been asked to make a DXF flie from each layout. I'm trying to make a DWG from each layout and then save each as DXF. 1. Is this the best way? 2. when using "_exportlayout" I get an error "Unhandled exception" when I hit Continue it will finish the command but I'm getting an invalid DWG. Please see attached the message, any advice? Thanks! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.