Jump to content

Bevel Gear Support in 3D AutoCAD


Bobzy20

Recommended Posts

I'm drawing this item in 3D AutoCAD and I wanted to see if I'm drawing it right.

 

All the fillets seem to clash with each other and I'm thinking I might have drawn it wrong?

 

Does anybody fancy drawing it and letting me know?

For a larger version of the Bevel Gear Support drawing see the link below:

http://iadesigns.com.au/53_Bevel_Gear_Support_exercise.jpg

Link to comment
Share on other sites

Looks like you might have drawn some portion of the part incorrectly that you ended up with the result shown above. Did you go back and check?

Link to comment
Share on other sites

I had the above measument at 25 but after chnaging it to 12.5 the 25mm fillet seems to fit ok and now meets the edge.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...