Jump to content
Bobzy20

Bevel Gear Support in 3D AutoCAD

Recommended Posts

Bobzy20

I'm drawing this item in 3D AutoCAD and I wanted to see if I'm drawing it right.

 

All the fillets seem to clash with each other and I'm thinking I might have drawn it wrong?

 

Does anybody fancy drawing it and letting me know?

For a larger version of the Bevel Gear Support drawing see the link below:

http://iadesigns.com.au/53_Bevel_Gear_Support_exercise.jpg

Share this post


Link to post
Share on other sites
ReMark

Looks like you might have drawn some portion of the part incorrectly that you ended up with the result shown above. Did you go back and check?

Share this post


Link to post
Share on other sites
Bobzy20

I believe I have drawn this arm (highlighted) wrong but I'm not sure how to draw it from the diagram.

Share this post


Link to post
Share on other sites
ReMark

Could you have picked the wrong face during the fillet command?

Share this post


Link to post
Share on other sites
Bobzy20

Check out my drawing.

Share this post


Link to post
Share on other sites
Bobzy20

Should this measurement be 25mm?

Share this post


Link to post
Share on other sites
ReMark

That radius (r=25) is really large.

Share this post


Link to post
Share on other sites
Bobzy20

I had the above measument at 25 but after chnaging it to 12.5 the 25mm fillet seems to fit ok and now meets the edge.

Share this post


Link to post
Share on other sites
ReMark

Yeah, I just got a solution too.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...