Jump to content

Help needed in building a helix sweep surface


jpolihro

Recommended Posts

i thought this may also help you. its a screen shot of my Relations/Snaps settings. This is under Tools>Options and on the System Options Tab. I think the important one is 3rd down, Automatic Relations.

solidworkshelp10.jpg

Link to comment
Share on other sites

  • Replies 21
  • Created
  • Last Reply

Top Posters In This Topic

  • shift1313

    12

  • jpolihro

    10

Top Posters In This Topic

Posted Images

Hi Shift1313

 

thanks for the pictures. I adjusted my tools/options settings. When I select 3d-sketch-->Point it is no problem to hover over the helix and get coincident constraint.

This never happens with line, though

 

I'll start another thread just on that. There is a subtle problem here.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...