Jump to content
darrellk-1

No objects shown in new view ports

Recommended Posts

darrellk-1

I am running LT2014, and have already created functioning layout view ports with correctly displayed objects. However, when I draw a new view port now, it does not have anything displayed in it. I have checked to insure all layers are on, layers are not frozen in view port, the view port is checked to display objects, the drawing is not corrupted, and I have done Zoom>E. Nothing seems to help here, is there a switch that I have accidentally turned off or on?

 

This seems to have started after I clipped an existing view port to fit page space better. Help!

Share this post


Link to post
Share on other sites
SLW210

Check the value of MAXACTVP, 64 is the maximum AFAIK.

 

If that is not the answer, post your drawing here.

Share this post


Link to post
Share on other sites
mwade93

You did check new vp freeze right?

Share this post


Link to post
Share on other sites
darrellk-1

I checked MAXACTVP AND IT WAS . I have checked to make sure layers are not frozen in new VP or in the current one either. I have done Zoom>Extents with no luck. Tried to upload the 2 MB file without success, but as I have not tried this before, I may not be doing it correctly. Is it just slow to upload, I waited about 5 minutes while the busy symbol work without success? I have fiber optic internet so that isn't it.

Edited by darrellk-1

Share this post


Link to post
Share on other sites
rkent

You may have some objects in MS that are a long way from the rest of the model. Go to model space and do a zoom extents. Does everything disappear? If so then go back to where you can see your model information, use erase, all, then remove, and with a crossing window select your model information. Now try zoom extents again.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...