Jump to content
FIFTHTEXAS

Cable Tray problem

Recommended Posts

FIFTHTEXAS

i am trying to connect cable tray at two levels , it is only giving me an option to connect using 90 degree

i am trying so it can slope to say 45 degrees any ideas, i can not seem to find connection.

what is right procedure

 

many thanks

Share this post


Link to post
Share on other sites
wildirish317

Let me preface this with stating that I have never worked with cable tray. Select a cable tray item in your project, go to "properties" and select "edit type". A window should open that lists the "type parameters". Under "fittings", you should see "horizontal bend", "vertical inside bend", "vertical outside bend", etc. If the values for these are shown as "none", you need to change them to the type fitting you want to use. If "none" is the only selection available, then you need to load the cable tray fittings that you want into the project. Once you get the fittings in the project, you can change the angle to suit your needs.

 

hth

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...