Jump to content

Precast


btobrien81

Recommended Posts

Hi everyone,

 

Is anyone here from within the concrete precasting industry? Our company are looking at switching into Revit Structure from AutoCAD. We mainly do 2D shopdrawings from files supplied by client, I feel this is the right move for the company going forward. Any ideas would be welcome.

 

Cheers/1

Link to comment
Share on other sites

Not many structural guys here, however at my last company I did a good share of structural designing in which Revit was the primary program. Lots of precast and monolithic designs, we even designed three schools in Micronesia that were all cast concrete structures, 100% Revit. Those three school designs turned out fantastic. So I can be some help, but http://www.RevitForum.org has a lot of structural Revit guru's over there so your time would be much more well spent over in a Revit-only forum instead of an predominantly AutoCAD-only forum such as CADTutor.net.

 

Hope this helps. :)

Link to comment
Share on other sites

Thanks Tzframpton,

 

I have register to the revit only forum which you suggested and i think its a very good idea. Perhaps i can catch up with you over on that forum where we can discuss my subject (Precast Concrete) more thoroughly, and perhaps other revit gurus can also contribute their brilliant ideas.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...