Sengna Posted September 3, 2015 Share Posted September 3, 2015 I created a sketch on the face where the red arrow points to and extrude to get the groove cut out. My question is how can i extrude exact same thing all around? is that possible? or do i have to creat sketch each of them one by one, thanks Roll Dia is 4 in Quote Link to comment Share on other sites More sharing options...
Sengna Posted September 3, 2015 Author Share Posted September 3, 2015 sorry the images repeated, how can i remove the same pics. Quote Link to comment Share on other sites More sharing options...
gazza_au Posted September 4, 2015 Share Posted September 4, 2015 Can't you mirror the feature or draw your wedge around a center point and revolve it. Quote Link to comment Share on other sites More sharing options...
Lazer Posted September 4, 2015 Share Posted September 4, 2015 Revolve Cut around a center axis will do it. Quote Link to comment Share on other sites More sharing options...
Sengna Posted September 9, 2015 Author Share Posted September 9, 2015 Can't you mirror the feature or draw your wedge around a center point and revolve it. gazza, how can i draw the wedge around? can u sketch on piece of paper and show me, sorry for late reply i was out of the office, just back. Quote Link to comment Share on other sites More sharing options...
MarkFlayler Posted September 9, 2015 Share Posted September 9, 2015 Attach your model and I am sure we can be of more help. We can't arbitrarily tell you to do something since our assumptions of how your part is modeled may not be accurate. If you cannot attach your model, lets start with a few basic questions. Is your initial sketch fully constrained? Is your part built symmetrically around the origin of the part file? Are your existing teeth part of a feature pattern (not a sketch pattern...shudder) Quote Link to comment Share on other sites More sharing options...
gazza_au Posted September 9, 2015 Share Posted September 9, 2015 Follow the pictures 1-4 and look carefully where the cursor is over. Create a sketch on the correct plane. Press F7 to slice graphics. Project geometry needed. Make new sketch. Cut around the correct axis. I think pictures 1 & 2 are the wrong way around, Hope this helps. Gazza Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.