ReMark Posted January 31, 2022 Share Posted January 31, 2022 (edited) 17 hours ago, JonnaMcSki said: Hello ReMark, thank you. I did not expect you to respond on Saturday. Good to know for next time. Had some free time on my hands and the playoffs weren't going to take place until Sunday. You lucked out. Edited February 1, 2022 by ReMark Quote Link to comment Share on other sites More sharing options...
autocadstudent1 Posted April 8, 2022 Share Posted April 8, 2022 Hello, In regards to the rebar placed within the footing of the drawing, how do i find the radius at which the bottom and sides curve up? Quote Link to comment Share on other sites More sharing options...
autocadstudent1 Posted April 8, 2022 Share Posted April 8, 2022 (edited) Hello, In regards to the rebar placed within the PIER how do i find the length of the rebar from bottom of the PIER to the footing? Edited April 8, 2022 by autocadstudent1 Quote Link to comment Share on other sites More sharing options...
ReMark Posted April 8, 2022 Share Posted April 8, 2022 Re: radius of rebar. I would use a 3 inch radius. Re: length. The instructions call for the rebar to have a clearance of 3 inches from each side and the bottom of the footing. The length will then be whatever the clearance dictates. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.