Jump to content
O'Huggin

Wall Corner Unable to Join

Recommended Posts

O'Huggin

Attached is a print-out of the reduced building I am trying to assemble.

 

I am intending to save a Revit file, just capturing the problem portion so that it can be accessible for diagnoses. But still, I can only go down to 884 kbytes, over the allowable 500 kbytes to upload. So, I settled to pdf-ing.

 

It shows two corners, 3 wall forming a U (as seen in plan). The walls are all of the same type and were created in identical procedure. What I don't know is why the right one is misbehaving with the appearance of unnecessary multiple vertical lines while the left part is clean.

 

I tried to use the trim (fillet) command, or right clicked on the grip, then disallowed joining so that I can manually meet the walls, or used the wall joins command but it won't get fixed.

 

What is the best way to clean this corner?

 

I wish I could have the actual file uploaded.

Wall Unable to Join.pdf

Share this post


Link to post
Share on other sites
welldriller

Is your right wall inserted as a "block" by any chance ?

Share this post


Link to post
Share on other sites
profcad

On the wall join tool, try switching it from butt to miter.

Share this post


Link to post
Share on other sites
nod684

have you tried splitting the ends of both wall?

split and delete the end walls and join them again

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×