Jump to content

Method to apply radius to a flat part


chubarka

Recommended Posts

Will someone here point out a method to apply a radius to the flat part shown in my attachment, similar to the shaped part? The radius is 2.6". I have never used the flex tool, would that be a possibility?

Thank you,

Chubarka

Image00024.jpg

Link to comment
Share on other sites

Flex will work but you Could Sweep it, male it from sheet metal or a few other methods. I would use sheet metal most likely but don't know what 2007 had. Sweep is my next option.

Link to comment
Share on other sites

I know how to use the sweep feature, however that had to be employed from the start, I need to bend this part now that it is all pierced and formed.

I don't know if sheet metal will put on the radius with the flange on it, I'm going to have to look into the flex tool. I suppose.

Thank you for your response,

Chubarka

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...