Jump to content
halam

Roundup a data extraction, how?

Recommended Posts

halam

Hi all,

I can make dataextraction on mass objects.

These objects are converted 3D solids to masses (not blocks!)

I notice that there are very, very little difference in the Volume calulations that make then unique. Which i don't want off course.

 

 

So, my question is this..

Is there a way to data some kind of round off BEFORE dataextraction..

See attached

dataextraction op basis van volume.jpg

cause of making it unique.JPG

Edited by halam
Extra screenshot to clarify

Share this post


Link to post
Share on other sites
JoeyG_77

Hey H, Did you figure out how to round off ?

Share this post


Link to post
Share on other sites
halam

Not yet. I was trying to get this under the attention of Autodesk. That is even harder since there is no 'ideas for AutoCAD' to begin with.. :x

Share this post


Link to post
Share on other sites
halam

I do think I know the cause. Precision issues in Revit :( Your looking at ex Revit families turning into DWG..

Share this post


Link to post
Share on other sites
JoeyG_77

H try .... right clicking on the column name you want to change ... it will say column format. Click on decimal and then it will say current precision. Click on that and it should change it for you. Once you do that make a copy of the dxe and use that as your template next time you have to do that extraction.

Share this post


Link to post
Share on other sites
halam

Change precision doesn't effect the results (amounts). Tried that as it would be the most obvious..

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×