Bill Tillman Posted November 16, 2018 Share Posted November 16, 2018 I keep running into the same issue with this dynamic block. I need to be able to both stretch and rotate it. But when I rotate it and then try to stretch it I don't get the results I want. As I experiment with the block I find that when I include what I think is needed AutoCAD reports that I have a circular reference in the block. ??? DynBlock101.dwg Quote Link to comment Share on other sites More sharing options...
dlanorh Posted November 16, 2018 Share Posted November 16, 2018 You need to include the stretch linear parameter in the rotate selection. See attached altered drawing DynBlock101.dwg Quote Link to comment Share on other sites More sharing options...
robwell Posted January 7, 2019 Share Posted January 7, 2019 Use a Polar Stretch instead of a linear stretch and rotate. See my example of an arrow. ARROW POINT.dwg Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.