smuthuc Posted November 22, 2018 Share Posted November 22, 2018 dear, i need to create new linetype for circle on lwpolyline vertexes only not in between vertexes and small gap from circle as i attached file thanking you Quote Link to comment Share on other sites More sharing options...
BIGAL Posted November 23, 2018 Share Posted November 23, 2018 A few different methods come to mind, trim the lines with a offset, use a wipeout then lines still go to centre of circle. I am sure this has been discussed before in particular lines going to a end point to reflect true length. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.