Jump to content

Recommended Posts





i need to create new linetype for circle on lwpolyline vertexes only not in between vertexes 

and small gap from circle as i attached file

thanking you


Share this post

Link to post
Share on other sites

A few different methods come to mind, trim the lines with a offset, use a wipeout then lines still go to centre of circle.


I am sure this has been discussed before in particular lines going to a end point to reflect true length.

Share this post

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...