Jump to content
Rob Preston

water tight 3d mesh

Recommended Posts

Rob Preston

Hi Not sure if I am placing this question in the right place. However! Could anyone please help me sort out a drawing in 3d . I  have made the outline drawing with a 3d mesh. But I keep getting a message that it cannot be converted to a sold as it is not closed?

Any help would be most welcome.

Regards Rob

Share this post


Link to post
Share on other sites
ReMark

It would help if we had access to a copy of the drawing.  I'm guessing that the file size will prohibit it from being uploaded and attached to a post here.  Therefore, make use of a file sharing website such as DropBox.  Upload the drawing to the website then post a link to it here.  In the meantime you should check the Autodesk Knowledge website for any articles that deal with watertight problems in meshes.  You'll learn what are some of the causes of watertight problems and read about possible solutions.

 

 

Share this post


Link to post
Share on other sites
Rob Preston
8 hours ago, SLW210 said:

I have moved your thread to the AutoCAD 3D Modelling & Rendering Forum.

Hi Thanks for the reply and for moving my post to the correct locatio. I.ll load up the file over the next few days

Regards Rpb

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...