Rob Preston Posted February 20, 2019 Share Posted February 20, 2019 Hi Not sure if I am placing this question in the right place. However! Could anyone please help me sort out a drawing in 3d . I have made the outline drawing with a 3d mesh. But I keep getting a message that it cannot be converted to a sold as it is not closed? Any help would be most welcome. Regards Rob Quote Link to comment Share on other sites More sharing options...
ReMark Posted February 20, 2019 Share Posted February 20, 2019 It would help if we had access to a copy of the drawing. I'm guessing that the file size will prohibit it from being uploaded and attached to a post here. Therefore, make use of a file sharing website such as DropBox. Upload the drawing to the website then post a link to it here. In the meantime you should check the Autodesk Knowledge website for any articles that deal with watertight problems in meshes. You'll learn what are some of the causes of watertight problems and read about possible solutions. Quote Link to comment Share on other sites More sharing options...
SLW210 Posted February 21, 2019 Share Posted February 21, 2019 I have moved your thread to the AutoCAD 3D Modelling & Rendering Forum. Quote Link to comment Share on other sites More sharing options...
Rob Preston Posted February 21, 2019 Author Share Posted February 21, 2019 8 hours ago, SLW210 said: I have moved your thread to the AutoCAD 3D Modelling & Rendering Forum. Hi Thanks for the reply and for moving my post to the correct locatio. I.ll load up the file over the next few days Regards Rpb Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.