Jump to content
bjenk8100

family rotations

Recommended Posts

bjenk8100

I hope this is a very simple problem.  I drew an office chair starting with the seat from a side profile width (left right) and height (up down) then extruded (into the screen for say) for depth.  When I try to load it into project it keeps wanting the put the side view normal to the floor.  I want the chair to stand up not lay on its side.  I have tried changing reference planes in family editor with no luck.  I have tried numerous family templates (generic model, detail and profile).  Any help would be greatly appreciated.

Family5.rfa

Share this post


Link to post
Share on other sites
bjenk8100

Nevermind,

 

The answer to my question is simple.  Make sure you are drafting in the correct view.  In this case I was in a plan view.  I copied and pasted my model in a family elevation view and reloaded it into my project  and everything worked fine.  

 

 

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...