Joeg Posted March 25, 2020 Share Posted March 25, 2020 How can I draw or what command to use for the highlighted in red on the drawing. "External link removed" - F7 Quote Link to comment Share on other sites More sharing options...
BIGAL Posted March 26, 2020 Share Posted March 26, 2020 Look at ellipse command. The red would be a trimmed 1/2. I take it your talking about a plan view not a 3d model. Quote Link to comment Share on other sites More sharing options...
Bob658 Posted April 16, 2020 Share Posted April 16, 2020 Just a bit more info on how to set the ellipse out. Quote Link to comment Share on other sites More sharing options...
steven-g Posted April 16, 2020 Share Posted April 16, 2020 Ellipse would give a very good approximation, but this is a 2D isometric drawing of an ellipse on an isometric plane at an angle to the 2D plane. In Reality the cicles shown would be true ellipses, how you construct the isometric ellipse is beyond me, other than drawing it in 3D and then using an isometric view. 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.