Jump to content
ajaxklapri

problem sweeping with bricsCAD

Recommended Posts

ajaxklapri

I kepp getting the error :  1 entity was not swept,

what i did is is , sellecting that circle at the end of the helix form and that clicked on sweep command, that selected the helix form as a path, than I get that  couldnt not turn to something error .

strugulling sweeping.png

Share this post


Link to post
Share on other sites
ReMark

Was that the full extent of the error message?  Perhaps the diameter of the circle is greater than the spacing of the coils of the helix?

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...