Jump to content

Architectural - Plumbing


cadmando-2

Recommended Posts

I am attempting to work on a Architectural project.

Someone was showing me how to do MEP.

my base project is Architectural drawing. I was told to put in sinks,  toilets, refrigerator, dishwasher, Hot water heater, washer and dry on this project.

I opened new project template as "mechanical" and link the project to do HVAC and plumbing.

I question if I should only have "sinks,  toilets, dishwasher, washer and hot water heater on this project.

In my "Project browser" selected Plumbing>Floor Plans> 1-Plumbing. I was then instructed to place sink on top the existing sing just to be able to hook up my plumbing!

Been doing AutoCAD over 30 years, this is my first time using Revit.

I seem logical to my that  "Plumbing>Floor Plans> 1-Plumbing" should only have plumbing fixture on this layer. am I wrong, or am I right. it doesn't seem right process to my. looking for video's for beginners for Architectural and MEP. I done HVAC on AutoCAD 2D so I figure out and I'm ok with that., Just know a little on Electrical and Plumbing.

can anyone point me in the right direction?

Looking for Video tutorials. 

 

Plus if I move what I did on the Mechanical template back you the first architectural under the HVAC project browser?

 

Edited by cadmando-2
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...