View Full Version : Viewing problem
1st Sep 2008, 08:50 pm
Each time i view my model with the standard orthographic and isometic views it zooms very far out and then i have to zoom back in again which can be time consuming.
Its probably simple but its got me for a while now.:glare:
2nd Sep 2008, 12:33 am
is there something there shouldn't be waaaaaaaaay outside your drawing area?
are you drawing with xrefs?
2nd Sep 2008, 01:39 am
When you switch orthographic views in your viewports, Max automatically resets the view to 0,0,0. If your model is not located at this position, it will appear zoomed out. Just click the little "Zoom Extents All" button in the lower right corner of your screen.
I don't know of any way to modify this behavior. :unsure:
2nd Sep 2008, 09:23 am
Yes i was using a large underlay scanned drawing that i completely forgot about. This was on xref and removed through layer management. Just deleted the the xref and that did it. Cheers guys
Powered by vBulletin™ Version 4.1.2 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.