PDA

View Full Version : Errors with blocks!!!!


neekcotrack
12th Sep 2008, 12:18 pm
I have resently updated to MEP 2009. The problem I am having is when I go to move any block in the drawing if the block crosses over and MEP duct the snaps snap to it an crash no matter what. There are only two ways I have found to fix it for now. Turn off all snaps before I move, or explode the block within the drawing and make another one. Has anyone had this problem? Yes I have talked to AutoDesk and there looking into it!!!!!!

But the quicker I can get this answered will help.
StykFacE
12th Sep 2008, 04:33 pm
I have resently updated to MEP 2009. The problem I am having is when I go to move any block in the drawing if the block crosses over and MEP duct the snaps snap to it an crash no matter what. There are only two ways I have found to fix it for now. Turn off all snaps before I move, or explode the block within the drawing and make another one. Has anyone had this problem? Yes I have talked to AutoDesk and there looking into it!!!!!!

But the quicker I can get this answered will help.
Have you installed all the latest updates, hot fixes, and Service Packs?

http://usa.autodesk.com/adsk/servlet/ps/dl/index?siteID=123112&id=2334435&linkID=9240938
neekcotrack
12th Sep 2008, 05:40 pm
Have you installed all the latest updates, hot fixes, and Service Packs?

http://usa.autodesk.com/adsk/servlet/ps/dl/index?siteID=123112&id=2334435&linkID=9240938

Yes that has been all updated and still the same thing. AutoDesk just said to reinstall which did not fix it either. I am so lost.
dumfatnhappy
12th Sep 2008, 10:16 pm
Check your memory (RAM). I was very unstable untill I doubled it to 8G. as I said in another thread, right click on the task bar, open task manager and check your physical memory against your RAM. You may be on the edge like I was....
dumfatnhappy
12th Sep 2008, 10:45 pm
the red is what I have on board

the blue is what I'm using....

I originally had 4g installed.....

now imagine the stability with that, all KINDS of crap was happening with no explanation....:shock:
neekcotrack
15th Sep 2008, 12:16 pm
the red is what I have on board

the blue is what I'm using....

I originally had 4g installed.....

now imagine the stability with that, all KINDS of crap was happening with no explanation....:shock:


My memory looks fine to me. How are you running 2009 MEP with so high of a memory usage? I usually run two at a time and mine still never gets about 50% of my RAM.
neekcotrack
7th Nov 2008, 08:53 pm
Ok Autodesk fixed the problem finally for me, in there update #2.