duece Posted September 21, 2008 Posted September 21, 2008 i have purchased inventor 2009 and am considering buying a cd called "inventor" by james a. sinclair which covers thru inventor 10.....question is, will the instructions be close enough between the (2) releases to start familiarizing myself with inventor 2009?????? any info would be appreciated.......... Quote
Lazer Posted September 22, 2008 Posted September 22, 2008 That cd will be fine, a few things have been added but the general modeling methods are the same. Quote
duece Posted September 22, 2008 Author Posted September 22, 2008 thank you for your input.....it's difficult to select tutorials....they vary anywhere from $50 to $500 and every one is supposed to be the best.....i'm going to try this cd as a starting point.......thanks again Quote
shift1313 Posted September 22, 2008 Posted September 22, 2008 i learned inventor10 just by using the preloaded help/tutorials. may be worth your time. Also i know Autodesk had some nice tutorials on their website for their other softwares, may be worth a look Quote
stevsmith Posted September 22, 2008 Posted September 22, 2008 A good website for inventor is Cad diget. Quote
Lazer Posted September 22, 2008 Posted September 22, 2008 These guys are fantastic, check out the tips on the right hand side of the page. http://askthecadgeek.blogspot.com/2008_09_07_archive.html Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.