Center of Gravity

Is the Centroid, the coordinates for the center of gravity?

I use Massproperties command and change the

Coordinate system to UCS

I tried to attach picture, but It wasn't allowed.

http://www.cadtutor.net/forum/attachment.php?attachmentid=7365&stc=1&d=1222274059

Thanks For any advice.

it should be the location of the center of mass, assuming uniform density material. It usually gives you a reference on screen. where is your ucs?

where is your ucs?

I think it is

I don't really know.

http://www.cadtutor.net/forum/attachment.php?attachmentid=7365&stc=1&

Make sure the picture is a .jpg

Sorry I dont know the awnser to the problem, but I do know that to attach a picture, you need a minimum of 10 posts...

Well noticed, that is why gbradley cannot post a picture, you need the 10 post count, the reason for this is to stop spam.

Yes I understand the Spam prevention.

I was able to upload a jpeg, and the link works OK, I just couldn't embed it into the post.

Different parts will have a different center of gravity.

The location of the Blue rectangles approx.

In the older versions of MDT it was pretty easy to get, but for some reason I am having trouble with this new version.

I was just hoping to verify that the Centroid was that point.

Thanks